-
Connect a cable between your terminal computer, power supply, and WMT700.
-
Open the HyperTerminal program.
-
Cancel the new connection.
-
Select .
-
Select the correct COM port and select Configure.
-
Set the communication parameters according to the configured port settings of WMT700.
The default values for WMT700 are:
Communication parameter |
Default value |
Bits per second |
9600 |
Data bits |
8 |
Parity |
None |
Stop bits |
1 |
Flow control |
None |
-
Select .
-
Select . Close the New Connection Properties window.
-
Select and in the Font list, select
Terminal.
-
Select . Type a name and select an icon for the connection. Select
OK.
When a serial line cable is connected to
the computer and the terminal setup is correct, switch the sensor power supply on. The
following information is displayed:
WMT700 v<version number>
The sensor goes to measurement mode
after 4 seconds and it is ready to receive measurement mode commands.
At the end of each command, press
ENTER to execute the command. The following combinations of carriage
return <CR> and line feed <LF> are accepted: <CR>, <LF>, and
<CR><LF>.The communication baud rate can be 300 ... 115200 baud.