The data messages can contain measurement data calculated by WMT700 and information on the status and properties of the wind sensor.
For the automatic message mode, you must set the following parameters:
- autoInt (defines the message send interval in seconds, 0.125 s resolution)
- autoSend (0 = automatic message mode disabled, for available messages, see the following table.
- autoPort (defines where the message is sent: 1 = COM1, 2 = COM2)
When the WMT700 protocol is used, you can use either one of the predefined message formats or user-configurable data message format.
The following table lists the data messages supported by WMT700. You need the data message numbers when you use the WMT700 protocol POLL command or the automatic message mode with any protocol.
Data message number | Description |
---|---|
WMT700 data messages | |
20 | WMT700 NMEA MWV profile message that reports average wind speed and direction. |
21 | WMT700 profile message that reports average wind speed and direction. |
22 | WMT700 profile message that reports wind speed in x and y components. |
23 | WMT700 profile message that reports wind speed and direction and self-diagnostics information. |
24 | WMT700 profile message that reports wind speed and direction and self-diagnostics information, and includes the checksum. |
25 | WMT700 profile message that reports wind measurement, sonic temperature, and status data, and includes the checksum. |
27 | ROSA - MES12 Standard profile message |
WS425 and SDI-12 messages | |
15 | WS425 A/B NMEA Extended profile message |
16 | WS425 A/B ASCII profile message |
17 | WS425 A/B SDI-12 profile message for M command |
18 | WS425 A/B SDI-12 profile message for V command |
19 | WS425 A/B NMEA Standard profile message |
32 | WS425 A/B WAT11 profile message |
User-configurable data messages | |
1 | Items defined by the user. |
2 | |
3 | |
4 |
To select a data message when using polling, specify the corresponding data message identification number in the polling command.
To select a data message when using automatic messages, use the configuration parameters.