To switch WMT700 from the measurement mode to the configuration mode, use the OPEN command.
$0OPEN<enter>| Name | Description |
|---|---|
| $ | Fixed $ character starts the command. |
| 0 | Sensor address. All sensors answer 0 address. |
| OPEN | The OPEN command |
| <enter> | To activate the command, press ENTER. |
After the OPEN command the sensor switches from measurement mode to configuration mode. The following symbol is displayed:
> If the port protocol is SDI-12, ("s
comX_protocol,1"), type 0OPEN <ENTER>. |