Replacing probe(s) with a different type - RFL100

If a single humidity or temperature probe is connected, you can simply turn off the data logger, remove the probe, and follow the appropriate setup procedure to connect the new type of probe:

• Setup with 1 humidity or temperature probe
• Setup with 2 temperature probes
• Setup with CO₂ probe

The following cases require that you perform a factory reset on the data logger before attempting to replace the probes:

• The data logger is currently set up with 2 temperature probes using the Probe Splitter M8 accessory, and you want to connect a probe that is not temperature-only.
• The data logger has a CO₂ probe connected using the Probe Splitter M8/M12 accessory, and you want to stop using a CO₂ probe.