- 1
- Power switch
- 2
- Probe splitter
- 3
- Latch of the battery cover
- 4
- Instruction label with short version of this setup instruction
- 5
- Probe connectors of the probe splitter
- 6
- Temperature probes
- 7
- Numbering labels for TMP115 probes (included in the probe mounting accessories)
|
CAUTION
To support operation with 2 temperature probes, the RFL100 data logger must have firmware version 1.2.0 or higher. Additionally, make sure the following components of your viewLinc Monitoring System are updated to at least the following firmware and software levels:
|
CAUTION
You must follow the procedure below to set up RFL100 with the probe splitter. The procedure includes steps to label the probes to make it easy to identify the channel assignment later. You can also use the info mode of the RFL100 to check which probe serial number is connected to which channel. |
Once the data logger has been set up for 2 temperature probes using the probe splitter, it requires a factory reset before it can be set up for one-probe mode or operation with a CO2 probe. |