Status LED. Blinks green for normal operation, red for error or alarm.
6
Signal strength of access point connection
7
Alarm indicators. Alarms are configured in viewLinc Enterprise Server
software.
8
Detachable probe, or extension cable
Figure 2. Under the silicone plug
1
Service port (micro-USB). If using external power supply, connect it here.
2
Info button. Push to enable info mode for 1 hour, and
again to end the info mode. Info mode cycles through information
screens, and also enables faster wireless scanning.
Figure 3. Rear and inside
1
Type label
2
On/off switch
3
Clock battery
4
Probe orientation mark. When connecting the probe, line up the markings on the
probe and above the connector before pushing the probe to the
connector.
5
Humidity and/or temperature sensors under the filter
6
Release button. Push to release RFL100
from its current viewLinc system, and allow it to connect to any
viewLinc system.
7
Main batteries. Use only non-rechargeable, AA size, 1.5 V alkaline (LR6) or
lithium (FR6) batteries.
8
Battery cover
Figure 4. Mounting bracket
1
6 mm (0.23 in) hole for hook mounting
2
Holes for mounting with cable ties
3
Strong magnet (in magnetic mounting bracket only).
Handle with care.
