4‑mm Allen key |
- Mount the DKPFIXP44H sensor support to the mast with the clamp and screws provided so that the center of the radiation shield, when mounted, is at approximately 2 meters (6 ft 7 in) height.
- Mount the radiation shield DTR13 to the support arm and fix it with the screws provided.
-
Remove the protective cover from the probe.
-
Lead the sensor cable through the connector cover, and attach the cable to the probe.
-
Loosen the screw of the sensor clamp with your fingers and insert the HMP155 probe in the larger outer hole at the bottom of the radiation shield.
-
Install the optional T‑probe.
- Insert the T‑probe into to the T‑probe adapter.
- Fasten the T‑probe into the adapter using the knob.
- Fasten the cable to the adapter with a cable tie.
- Insert the adapter into the smaller outer hole in DTR13.
- Push the connector cover over the probe connector.
- Tighten the screw without using excessive force.
- Lead the sensor cable along the support arm and attach the cable to the support arm with cable ties. Connect the sensor cable to the M12 connector in HMP155.