Probe structure - TMPX - HMP1 - HMP4 - HMP3 - MMP8 - HMP5 - HMP8 - HMPX - MMPX - HMP7 - TMP1 - HMP9

HMP Series with MMP8 and TMP1 User Guide
Document code
M212022EN
Revision
K
ft:locale
en-US
Product
HMP1
HMP3
HMP4
HMP5
HMP7
HMP8
HMP9
HMPX
MMP8
MMPX
TMP1
TMPX
Document type
User guide
Figure 1. Probe parts
1
Protection cap (remove before use)
2
5-pin M12 connector
3
Probe body with type label
4

Status indicator LED:

Green
Power on and probe online, flashes when communicating
Red
Error
Off
Power off, or indicator disabled
5

Fixed probe cable, variable length (do not cut).

HMP1 model does not have a probe cable, as its probe head is directly attached to the probe body.

6
Probe head (HMP7 model shown)
7
Location of sensor(s) on the probe head. Other probe models have a removable filter over the sensors but HMP1, HMP9, and TMP1 do not.
8
Protection cap (remove before use)

To prevent the warming of the indicator LED from causing a slight measurement error, HMP1 keeps the indicator normally off (even when power is on). The same applies to HMP3 and HMP7 probes that have a 0.15‑m (0.49‑ft) probe connection cable. If the probe is in error state, the red LED is shown.