SET PARAMETER is used for setting a given parameter to a given value.
The message can be used for the following purposes:
-
Stop continuous data reporting.
-
Set reference values.
-
Set offset to road and air temperature.
-
Configure the serial port speed.
-
Configure units of reported quantities.
Some of the parameters are read-only. An attempt to set a value to a read-only parameter causes an INVALID DATA error. |
Some of the parameters require a restart for the changes to take effect. The reported parameter value is reported immediately. |
The response times can be longer when parameter values are changed. The extra time is needed to write parameters into the permanent memory before sending the response. |
Message ID |
0x41 | ||
Data in request |
Offset |
Data |
Size in bytes |
7 | Parameter ID | 2 | |
9 | Parameter value | 1...4 | |
Data length |
3...6 | ||
Data in response |
None |