Configuring Modbus protocol - OPT100

OPT100 Installation Guide
Document code
M211857EN
Revision
V
Language
English
Product
OPT100
Document type
User guide
Figure 1. Modbus settings page
  1. In the user interface, select Settings > Network > Modbus.
  2. Select the connection type(s) for which Modbus protocol should be enabled. Select TCP (Ethernet), RTU (serial line), or both.
  3. If you enabled Modbus RTU, configure the serial connection:
    1. Select Baud rate for the connection. Available options are:
      • 4800
      • 9600
      • 19200
      • 38400
      • 57600
      • 115200
    2. Select Transmission mode, 8E1 or 8N2.
    3. Enter the Modbus Slave ID for the DGA monitor. Range 1–247.
  4. Click Apply to save your changes.