Installing Ground Mounting Set - OPT100

OPT100 Installation Guide
Document code
M211857EN
Revision
V
Language
English
Product
OPT100
Document type
User guide

  • Ground Mounting Set (Vaisala item OPTMSET2)

    • Mounting stand (delivered in three parts)
    • Wedge anchors (6 pcs) for securing the mounting stand to ground
    • Screws, washers, and nuts
  • 6-mm Allen key
  • 13-mm wrench
  • Impact drill and bits
Use the Ground Mounting Set when a free standing installation of the DGA monitor is needed. The mounting surface must allow the use of wedge anchors to secure the mounting stand. A concrete surface that is at least 100 mm thick is recommended.
Figure 1. Assembly of the mounting stand
1
Mounting holes on the top are for attaching the DGA monitor.
2
Mounting holes on the side join the parts of the mounting stand together.
3
Holes on the bottom (three on each side) are for anchoring the mounting stand to the ground.
4
Attach the power supply unit to the middle part using these four holes.
  1. Assemble the mounting stand. Tighten the screws to finger tightness at this point, not all the way.
  2. Using the assembled mounting stand as the template, mark the locations of the six anchors on the mounting surface. If the mounting location is at the edge of a concrete slab, leave at least 10 cm (4 in) clearance to the edge.
    Figure 2. Anchoring holes on the mounting stand
  3. Drill holes for the anchors using an impact drill and an 8 mm (.315 in) drill bit. The holes must be 60 mm (2.36 in) deep.
  4. Install the anchors in the holes.
  5. Attach the mounting stand to the anchors.
  6. Verify that the mounting stand is securely anchored.
  7. Attach DGA monitor to the top of the mounting stand.
  8. Tighten the screws to 20 Nm tightness.
  9. It is recommended that you connect oil pipes or hoses and cables to the DGA monitor before attaching the Power supply unit (PSU). See Installing oil lines.
  10. Attach the power supply unit to the middle of the mounting stand.