Attaching foundation bolts to mast foundation - DKP206AV - DKP206W - DKP210AV - DKP210W

DKP206 and DKP210 User Guide
Document code
M210315EN
Revision
F
Language
English
Product
DKP206AV
DKP206W
DKP210AV
DKP210W
Document type
User guide
  • Steel wire
  • Electrical tape
  1. Attach the foundation bolts to the nuts on the metal plate and orientation template.
    Make sure that approximately 80 mm (3.15 in) of the foundation bolts is above the surface of the mast foundation.
    1
    Foundation bolt (4 pcs)
    2
    Nuts (12 pcs)
    3
    Orientation template (1 pc)
    4
    Metal plate (1 pc)
  2. Attach two 2‑by‑4‑inch wood planks with screws to the cast mold so that they hold the template in the middle of the cast mold.
  3. In the cast mold, attach the template assembly with screws to the planks and with wire to the steel reinforcement bars.

    Check the correct orientation of the template and that the template is at the same height as the top of the finalized concrete block.

  4. Check that the mast foundation bolts are at the correct height, vertical, and on the same level with each other.
    Make sure that approximately 80 mm (3.15 in) of the foundation bolts is above the surface of the mast foundation.
  5. Place 2 cable conduits to the cast mold and tie the cable conduits with wire to the steel reinforcement bars.
  6. To protect the threads of the foundation bolts from concrete splashes, use electrical tape or similar.