Attaching probes and cables - INDIGO200SERIES - INDIGO201

Indigo201 User Guide

Document code
M212842EN
Revision
B
Language
English
Product
INDIGO200SERIES
INDIGO201
Document type
User guide
CAUTION Only connect compatible measurement devices to the transmitter. Attempting to connect incompatible devices or cables can damage the equipment. Refer to transmitter specifications for compatibility information.
Figure 1. Attaching probes and cables to Indigo200
1
Probes are locked in place with the locking wheel. Never turn from the probe body.
2
Connect probe cables in the same way as probes: insert the cable in the connector and hold in place while turning the locking wheel.
3
Insert probes into the probe connector with the orientation mark facing out.
  1. Insert the probe into the probe connector with the orientation mark on the probe body facing out.
  2. Hold the probe in the probe connector and lock it in place by turning the locking wheel counterclockwise. Do not turn the probe body when attaching, only the locking wheel on the transmitter.
  3. If no previous configuration exists (that is, this is the first time a probe is connected to Indigo, and no configuration has been set manually), Indigo adapts the analog output settings of the connected Vaisala Indigo-compatible probe automatically.
    If a configuration that differs from the attached probe's configuration exists in the transmitter, you must configure the new probe manually to enable analog output. See Analog output configuration overview.