USB connection to Insight PC software cannot be established |
USB connection has been disabled with the DIP switch on the transmitter component
board. |
See the instructions in Disabling and enabling USB functionality with DIP switch. |
Functionalities are not available in Insight PC software. |
Insight PC software is in Basic
Mode. Certain functionalities are only available in Advanced Mode. |
Change the user mode from Basic
Mode to Advanced Mode in the Insight PC software main view Settings menu. |
Measurement performance affected after calibration. |
Probe has not been switched from calibration mode to normal operating mode in the
Insight PC software. |
Open the calibration menu in the Insight PC software (). Exit the calibration menu with the Close selection, and ensure that you confirm closing the calibration mode when exiting
with the Yes selection. |
Analog output appears incorrect. |
The analog output channel Adjustment mode has not been switched off after adjustment. |
Open the analog output adjustment menu in the Insight PC software and switch the
adjustment mode off. See Analog output configuration overview. Note that each of the 3 analog
outputs has its own configuration menu. |