To take a new sensor into use after the
initial configuration, install the sensor and enable it in the Web UI. The sensor parameters
to be enabled are located in the features parameter group.
If a sensor is malfunctioning, you can disable it in the configuration to stop the related
error messages.
Table 1. Sensor parameters
| Before adding a new sensor after the initial configuration, make sure that the
station provides enough power for the sensor. |
|
|
AQT_1 |
Air Quality Transmitter AQT530 |
DSC_1 |
Remote Road Surface State Sensor DSC211 |
DST_1 |
Remote Road Surface Temperature Sensor DST111 |
GMP_1 |
Carbon Dioxide Probe GMP252 |
PWD_1 |
Present Weather Detector PWD22 |
WXT_1 |
WXT530 Series Weather Transmitter |
-
In the Web UI, go to .
-
Under the parameter group features, locate the parameter of the sensor you want to enable, for example, WXT_1 for WXT530 Series Weather Transmitter.
-
To enable a sensor, set the Active value of the parameter to on.
-
To disable a sensor, set the Active value of the parameter to off.
-
To save the changes and take them into use, select Save and restart
script.