It may be necessary to change the segment of
an RFL100 data logger to conform to your device installation plan, improve connectivity, or
make room in a full segment. If there is no need to relocate devices physically, the move
can be done remotely using the Sites Manager view of viewLinc Enterprise Server.
| Moving a data logger to a
different VaiNet segment using this procedure will not affect the linking of measurement
channels to locations in viewLinc. All currently linked channels will remain linked, and no
data will be lost. There is a break in data transfer as the data logger is rejoining the
system through the new segment, after which pending data is transferred. |
-
Log in to the viewLinc Enterprise Server as an administrator.
-
Navigate to .
-
Enable installation mode on at least one access point that belongs to the target
segment. Right-click on the access point in the device list of Hosts and Devices tab and select Edit Properties.
The access point should have free connection capacity (currently connecting less than
the maximum 32 data loggers) and it should be in range of the data logger that you want to
connect to the target segment. If you want to move a large number of data loggers, it may
be best to enable installation mode on all access points in the target segment.
-
Make sure installation mode is not enabled on any access point that is not assigned to
the target segment.
| Installation mode is automatically disabled after 8 hours. |
-
Locate a data logger you want to move to the segment from the device list. Right-click
it and select Release Device from
Access Point.
It will take some minutes for the release command to be delivered to the data logger,
after which it will automatically start to listen for access points that are in
installation mode. Data is not transferred from the data logger to viewLinc during this
time. The data logger will rejoin the system through the new segment without having to
be accepted again by the viewLinc administrator, and data transfer will automatically
resume.
-
Release all other data loggers you want to move to the target segment.
-
Wait for the rejoining to be completed, and verify from the device list that all moved
data loggers are now connected to an access point in the target segment.