Probe Mounting Using the Duct Installation Kit - 210697 - HMP3 - HMP7 - HMT330 - SWINSIGHT10
Duct Installation Kit 210697 Installation Guide
- Document code
- Document type
- User guide
Thread the clamping bush, nut, and supporting bar onto the probe cable.
Thread the hanger to the probe and then thread the supporting bar to the hanger. Fasten
the bushing around the cable and the supporting bar.
Pass the probe through the flange, and thread the nut to the flange.
Fasten the seal to the flange.
Make a Ø 20 mm hole in the surface of the chamber or duct.
Insert the probe through the hole and fasten the flange using screws and washers.