This document describes how to set up WM80 using the Vaisala-provided mounting adapter and alignment tool.
Available from Vaisala
- 1
- Vaisala Ultrasonic Wind Sensor WM80
- 2a
-
50-mm mounting adapter for pole with outer diameter 48–51 mm (1.89–2.01 in)
- 2b
-
60-mm mounting adapter for pole with outer diameter 58–61 mm (2.28–2.40 in)
- 2c
-
50-mm isolated mounting adapter for pole with outer diameter 48–51 mm (1.89–2.01 in)
- 3
- Alignment tool
- 4
- Device cable
| This document uses mainly the 50-mm standard mounting adapter to show the installation steps, but the information applies to all 3 mounting adapters. |
Other needed equipment
- 1
- Laser pointer Laserboy II (by BMI Messzeuge) for use with alignment tool (optional)
- 2
-
Allen key 4 mm
Allen key 6 mm (for isolated mounting adapter)
- 3
- Tools and accessories for wiring
- 4
- Electric joint compound (suitable for aluminum) (do not use with isolated mounting adapter)
- 5
- Self-vulcanizing tape (if required by your application)
| Some electric joint compounds contain fluoride etchants which may react with certain materials. Check material compatibility before use (see the electrical joint compound manufacturer's data). |
For device configuration
For device configuration, use the USB configuration set. See WM80 User Guide (M212995EN).