Powering - DA10

DA10 Installation Guide

Document code
M212894EN
Revision
B
Language
English
Product
DA10
Document type
User guide
WARNING Only licensed experts may install electrical components. Ensure that mains-connected equipment, power supplies, and installation accessories adheres to local and state legislation and regulations.
WARNING Take precautions before installation. Check that the instrument has not been damaged during transportation. Do not connect the instrument to the AC mains and do not carry out electrical tests before you have made sure that it is safe to power up the instrument.
WARNING Make sure that you prepare or connect only de-energized wires.
WARNING Keep away from live circuits. Operating personnel must observe safety regulations at all times.
WARNING Do not replace components when the system is powered up. Disconnect all power sources before performing maintenance procedures.
WARNING Do not operate in an explosive atmosphere, for example, when flammable gases or fumes are present. Operation of electrical equipment in such an environment constitutes a safety hazard.
WARNING Do not open the power supply unit. There are no user-serviceable parts inside the unit. If the power supply unit is faulty, replace it.
WARNING Make sure that nobody is viewing the unit from the beam direction with magnifying optics.
CAUTION Always use the specified cables. The wrong type of cable can damage sensors or the system.
CAUTION Do not damage or change the wiring. Incorrect wiring can cause damage and prevent or limit operation.
To prevent electrostatic discharge, avoid touching component contacts or connectors.

The power cable plug (EU and US version) is specified to a maximum of −40 °C (−40 °F). Do not install or exert mechanical stress on the plug when the temperature is below −40 °C (−40 °F).

The power supply must be protected with a fuse. The maximum sizes of the fuses protecting the power line:
  • 10 A for 230 V supply
  • 15 A for 120 V supply
  1. Connect the power cable.
  2. On the interface unit, turn the mains switch ON.

    Check that the power supply status is OK (DC power status LED is green).

    1
    AC (mains) power switch
    2
    DC power status LED