Installation workflow - INDIGO300

Indigo300 User Guide

Document code
M212849EN
Revision
B
Language
English
Product
INDIGO300
Document type
User guide

Installing the transmitter consists of these steps:

  1. Opening transmitter cover
  2. Mounting
  3. Wiring
  4. Finalizing installation
  5. Connecting probes

Once a probe is connected, the transmitter starts to output measurement data. If you want to get an automatic date and time setup for the transmitter or configure additional device settings, connect the transmitter to the Insight PC software or the Indigo80 handheld indicator through the service port on the transmitter's top cover.

The service port connection to Insight or Indigo80 can also be used to power up the transmitter and the connected probe temporarily, so you can configure device settings even before mounting and wiring, if needed. This is useful, for example, when the installation location is tight.

Note that while the transmitter and probe are powered through the service port, the supply voltage may not be sufficient to provide all functions of the probe.

CAUTION The service port connection is only intended for temporary use during configuration, and must not be used for permanent installations. The IP rating and EMC properties of the transmitter can be affected when the service port is open.