This product is intended for outdoor use and can be used in wet locations.
| WARNING Failure to comply with these precautions or with specific warnings elsewhere in these instructions violates safety standards of design, manufacture, and intended use of the product. Vaisala assumes no liability for the customer's failure to comply with these requirements. |
| WARNING Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. |
| WARNING If the equipment is used in a manner not specified by Vaisala, the protection provided by the equipment may be impaired. |
| WARNING Follow local and state legislation and regulations on occupational safety. |
| WARNING Assess the risks from the installation work. Consider also the effects of local weather conditions. |
| WARNING Do not perform installation or maintenance procedures when there is a risk of thunderstorm or lightning activity in the area. |
| WARNING Check that the instrument has not been damaged during transportation. Do not install or operate a damaged instrument. |
| WARNING Only licensed experts may install electrical components. They must adhere to local and state legislation and regulations. |
| WARNING Make sure that you prepare or connect only de-energized wires. |
| WARNING The AC (mains) power
supply line must be equipped with an overcurrent protection device (a fuse or a circuit
breaker). The current rating of the overcurrent protection device must be aligned with the
cable size used to connect PSU501. Unless local regulations state otherwise, use a maximum
of 6 A device for 0.75 mm² (18 AWG) cables, a maximum of 10 A device for 1 mm² (17 AWG)
cables and a maximum of 16 A device for 1.5 mm² (15 AWG) cables. Do not replace the AC (mains) supply cable with a cable that has a lower rating than specified. |
| WARNING Keep away from live circuits. Operating personnel must observe safety regulations at all times. |
| WARNING Do not replace the battery with a battery of an incorrect type. If you do, there is a risk of explosion. Dispose of used batteries according to statutory regulations. |
| WARNING Do not throw the battery into a hot oven or fire, or mechanically crush or cut the battery. Improper disposal can cause an explosion. |
| WARNING Do not leave the battery in an environment surrounded by extremely high temperatures. Extremely high temperature can result in an explosion or the leakage of flammable liquid or gas. |
| WARNING Make sure that the battery is not subjected to an extremely low air pressure. Extremely low air pressure can result in an explosion or the leakage of flammable liquid or gas. |
| WARNING To avoid exposure to laser radiation, do not disassemble AQT530 unless instructed to do so in AQT530 maintenance instructions. |
| CAUTION EGW501 requires a separation distance of at least 20 cm (7.87 in). This distance must be maintained between the user and the device when the device is operating. |
| CAUTION Make sure that the grounding wire is longer than the phase and neutral wires. Under mechanical stress, the grounding wire must be the last to disconnect from the protective ground terminal. |
| To prevent electrostatic discharge, avoid touching component contacts or connectors. |
| Vaisala Air Quality Transmitter AQT530 is classified as a Class 1 laser
device in accordance with International Standard IEC 60825-1. It complies with 21 CFR
1040.10 and 1040.11 except for conformance with IEC 60825-1 ED. 3., as described in the
Laser Notice No. 56, dated May 8,2019. A Class 1 laser device is safe under all conditions
of normal use. AQT530 incorporates a Class 3B laser. The laser is contained in an enclosure, preventing direct physical access to laser radiation. |
| When working with equipment in extremely cold temperatures, use appropriate personal protective equipment such as thermally insulated gloves and clothing. |
| Wear personal protective equipment (PPE). |