|Tie cables to the mast with cable ties.|
|Connecting the power cable to EGW501 automatically switches on the station if power is available from battery or other power source.|
| If the battery is fully
discharged, you have to wait until the battery reaches a sufficient state of charge to power
up the station.|
|EGW501 operating voltage||
9 … 32 V DC
|PSU501 input power||
100 … 240 V AC
50 … 60 Hz
Connect the sensors to EGW501.
CAUTION Sensor cables are not interchangeable. Incorrect cable can cause damage and prevent or limit operation.
Connect power source to PSU501.
- AC (mains) power to AC in
- DC power to DC in
If both AC (mains) and DC power source are connected, PSU501 provides DC power to the BWS500 station when AC (mains) power is not available.
For AC (mains) connection, you must prepare the AC connector before connecting cables. For instructions, see document Preparing AC (mains) power connector (provided with the connector).
- Connect PSU501 to EGW501.