Configuring environmental compensations with Insight - MGP261 - MGP262

Using Insight, you can configure the following temperature and pressure compensation settings:

• Temperature or pressure compensation mode (select the source where the compensation value is received from)
• The setpoint values for temperature or pressure compensation
• The scaling of the analog input channel (Analog input 1) that is used to receive temperature or pressure values from an external sensor.

Figure 1 describes the different environmental compensation selections in Insight.

1

Compensation power-up defaults: configure the setpoint compensation values that are taken into use at device reset. Used when the temperature or pressure compensation mode is set as Setpoint.

2

Compensation setpoints: configure the temporary setpoint compensation values that are in use while the device is powered on, but revert back to power-up defaults when the device is reset. Used when the temperature or pressure compensation mode is set as Setpoint.

3

Measurement (shown in figure): configure the pressure and temperature compensation modes (available options: Setpoint, External, Measured (temperature only), and Off.

4

Analog input 1: configure the input from the external pressure or temperature sensor (used when the pressure or temperature compensation mode is set as External).