| The laptop must support an
Ethernet connection. |
Before you start, make sure that:
-
You know the IP address of the device
you are updating. The following instructions use the default IP address
192.168.2.102
.
-
You know the admin password for the
device. (Set the admin password during device activation, see CL61 Installation Guide
(M212474EN).)
| The software update
interrupts measurements. |
-
Connect your computer to the same network as the ceilometer.
Use the Ethernet maintenance cable.
| CAUTION Remove the Ethernet maintenance cable after setup. It is not
intended for permanent installation. |
-
Configure your computer settings to match the device (ceilometer) network
settings.
-
Browse to the folder where you extracted the software package on your computer.
-
Open Vaisala Field Application.
-
Type the device IP address.
-
Log in with username and password.
-
Select .
-
Select Browse, browse to the software package you extracted, and
select Open.
-
Select Update Firmware.
Vaisala Field Application confirms the
overall device status.