List of commands - CL61

The user commands are divided into the following groups:

• Configuration commands include commands such as get, level, and set, as well as the configuration parameters.
• Troubleshooting commands include elog, reset, status, and system.

To access the user commands, establish a maintenance terminal connection and provide the password. The command prompt opens.

Table 1. CL61 user commands

Command	Description
configure sender	Stores STFP server settings to ceilometer.
elog	Displays the event log.
get <parameter>	Displays the parameter value or parameter list values.
getset <parameter> [<value>]	Displays the parameter value or parameter list values with the SET command included.
help	Provides help on the commands and use.
level [0∣1∣2]	Changes the user level (0, 1, or 2). The levels are: 0 = Read access (default) 1 = Write access to basic parameters 2 = Write access to advanced parameters
mode <mode>	Changes the device mode to cleaning and calibration. The modes are: adjustlaserref = for adjusting the laser power measurement, typically after transmitter replacement adjustcleanwindow = for adjusting the window condition measurement, typically after transmitter replacement
reset	Resets the device.
set <parameter> [<value>]	Sets the parameter value or parameter list values.
status	Displays the functional status of the device.
system	Displays information about the device.
system licences	Shows the list of OSS licenses.

For more information and the list of parameters, see CL61 User Guide (M212475EN).

You may request a copy of certain open source code as required by certain applicable OSS licenses by sending an email to opensourcesw@vaisala.com with the subject line "OSS source code request".