CWL100 data logger has a small button next to the service port. Pressing this button enables Info mode for 1 hour, after which the mode is automatically disabled. Pressing the button again disables the mode immediately.
In the Info mode:
- Data logger starts radio scanning immediately if it has shut down to save power.
- After showing the current measurement
results and possible error codes, the data logger shows the text INFO
ON and the following additional information:
- If the data logger is connected to an
access point:
- Signal strength indicator is updated faster, approximately every 30 seconds.
- The currently connected access point channel is shown, alternating with measurement results and firmware version.
- Firmware version of the data logger.
- Serial number of probe detected at startup, shown in 3 separate segments. Letters SN are shown before the number.
- If the data logger is connected to an
access point:
After all information has been shown, the same sequence is repeated until Info mode is disabled or 1 hour has passed.