See
images A and B at the beginning of this document.
-
Open the 2 hex screws on the cover of the transmitter using a 4-mm Allen key.
-
Open the transmitter cover.
-
Hold the transmitter level against the installation surface and use a pen to mark the
places of the mounting holes. The mounting holes are 157 mm (6.18 in) apart.
-
Drill 55 mm (2.17 in) deep holes and insert wall plugs.
-
Mount the transmitter to a wall using 2 screws and a crosshead screwdriver. Place nylon
washers under the screws to protect the surface of the transmitter.
When you close the transmitter cover, tighten
the hex screws to 4.5 Nm.