Ethernet connector and lead-through - INDIGO520 - INDIGO500SERIES - INDIGO510

Indigo510, Indigo520 Quick Guide

Document code
M212290EN
Revision
D
Language
English
Product
INDIGO520
INDIGO500SERIES
INDIGO510
Document type
User guide
You must use a shielded cable to meet the rated EMC performance of the device.

Before connecting wires or cables, make sure that the transmitter is powered off.

The 8P8C (RJ45) Ethernet connector is located on the inside of the transmitter cover. The supported standards are 10BASE-T and 100BASE-TX.

For the M20×1.5 cable gland with split bushing, the cable diameter is 7 mm (0.28 in).

When configuring the non-display transmitter, the Ethernet connector can be used without taking the cable through the cable gland. Always wire through the cable gland for more long-term wiring.
When you insert the cable through the gland parts, also remove the split bushing (3) inside the nylon seal (2) to make the cable fit through the seal. Then place the bushing around the cable and push it back inside the seal. See the following figure.
Figure 1. M20×1.5 cable gland with split bushing
1
Base of the cable gland
2
Nylon seal
3
Split bushing inside the seal
4
Nut of the cable gland