Attaching probes - INDIGO520 - INDIGO500SERIES - INDIGO510

Indigo510, Indigo520 User Guide

Document code
M212287EN
Revision
M
Language
English (United States)
Product
INDIGO520
INDIGO500SERIES
INDIGO510
Document type
User guide
CAUTION The IP classification of probes is valid only when the probes are attached to the probe cable.
If you want to configure the probe settings, such as purge interval, you must do that before attaching the probe to the transmitter. To configure the probe, you can use the free Vaisala Insight PC software. For more information, see your probe's user guide and visit www.vaisala.com/insight.
If your transmitter was delivered with preconfigured analog outputs, make sure that you connect the probes accordingly. See the label inside the transmitter enclosure for the correct order of the probes.

When the probe cables have been wired to the transmitter, you can attach and detach probes both when the transmitter power is on and when it is off. If the power is on while you attach or detach a probe, the transmitter shows a notification about the probe. If you have configured the transmitter to use outputs, the transmitter also notifies you of the state of the outputs.

Attach only Vaisala Indigo compatible probes to the transmitter.

Figure 1. Attaching probes to transmitter using probe cable connector
1
Probe cable, probe 1
2
Probe cable, probe 2 (dual-probe support in Indigo520)
3
Probe to be connected as probe 2 (GMP252 example)
4
Probe to be connected as probe 1 (HMP7 example)
5
Probe cable connector (5-pin M12)
You can attach the probes to the wall using the mounting accessory provided with the probes.