Make sure that you have the replacement spare part available.
Switch off both AC (mains) power switch and battery switch.
Make sure that there is no AC (mains)
power available for the system.
1
Battery switch
2
AC (mains) power switch
Remove the protection cap from the side receiver.
Remove the hood by opening the 3 screws that hold it in place and opening the connector
that connects the hood to the receiver.
CAUTION Be careful when removing the hood to avoid damaging the
connectors.
1
Side receiver hood
2
Side receiver module
3
Spring washer B4 DIN127 (3 pcs)
4
Screw M4×16 DIN912 (3 pcs)
5
Screw M2.5×8 ISO14583 (4 pcs)
6
Spring washer B2.5 DIN127 (4 pcs)
7
Connector (receiver)
8
Connector (hood)
9
Gasket
Open the 4 screws that hold the side receiver module in place.
Carefully detach the connectors under the side receiver module. Remove the side
receiver module.
Attach the connectors of the replacement side receiver module. Make sure that the parts
of the connector snap in place and you hear a click.
Attach the side receiver module with 4 screws.
Attach the connector between the hood and the side receiver module.
Make sure that the parts of the connector
snap in place and you hear a click.
Attach the hood with 3 screws.
The transmitter and receiver hoods are not identical.
The transmitter window is transparent and the receiver windows are black. Check carefully
before replacing the hood.
CAUTION Make sure that the gasket is in the right place.
Make sure that no cables are in the optical path inside the receiver.
Reattach the protection cap.
Power up the system.
Perform calibration adjustment (modeadjust) with the field calibrator kit (FDA701).