The following commands are available for use in the command line interface (CLI) of FD70.
| Command | Description | Reference |
|---|---|---|
|
open [<device type identifier> ] [<device identifier>] open [<device type identifier> ] * |
Establishes maintenance connection to the system. Use asterisk (*) (hex 0x2a) to access a device with an unknown device identifier. |
OPEN command |
| close | Closes maintenance connection to the system. | CLOSE command |
| get <parameter> | Returns the value of a given parameter. | GET command |
| set <parameter> <value> | Defines the value of a given parameter. | SET command |
| getset <parameter> <value> | Returns the value of a given parameter preceded by SET. | GETSET command |
| help | Lists available commands. | − |
| level <level> |
Sets user access rights for the session. Levels are:
|
LEVEL command |
| mode <mode> [receiver] |
Changes the device mode to cleaning and calibration.
|
MODE command |
| status | Shows status of the system. | STATUS command |
| elog [count] |
Displays event log.
elog clear hides entries elog --cleared shows hidden entries |
ELOG command |
| system | Lists information about the device, including serial numbers and software versions. | SYSTEM command |
| reset | Resets the system. | RESET command |
| swupdate <target> <link> | Updates the software. | Updating software on site |
|
This product uses open source software. Use the command SYSTEM LICENCES to view the list of OSS licenses. Executing the command over a serial line may take a long time. |
| You can request a copy of specific open source code as required by applicable OSS licenses. Send an email to opensourcesw@vaisala.com with the subject line OSS source code request. |