Calibration and adjustment using trimmers - HMD60 - HMD62 - TMD60 - TMD62

HMD62 TMD62 User Guide

Document code
M212016EN
Revision
D
Language
English
Product
HMD60
HMD62
TMD60
TMD62
Document type
User guide

HMD60 transmitters have 2 separate trimmers for RH and T measurement output adjustment mounted on the component board. The trimmers allow for easy 1-point adjustment of the measurement output against a reference with a known value.

The transmitters are shipped with the trimmers centered. Turning the trimmer counter-clockwise decreases the measurement output value, and turning clockwise increases the value. Figure NN shows the trimmer adjustment ranges for RH and T (-5 %RH … +5 %RH and -0.3 °C … +0.3 °C (-0.54 °F … +0.54 °F).

Figure 1. RH and T adjustment trimmer ranges (indicative)
The trimmers will only turn 135 degrees each way, less than half a rotation. Do not force the trimmer past the stopping point.
CAUTION If you use the Insight PC software to adjust the measurement or to restore the factory settings, always return the physical trimmer to the middle position before starting. When you make an adjustment with Insight, the position in which the trimmer is at that point is set as the ±0 point.