Wiring Options - INDIGO200SERIES - INDIGO202

Indigo 202 User Guide

Document code
M211966EN
Revision
B
Language
English (United States)
Product
INDIGO200SERIES
INDIGO202
Document type
User guide
Figure 1. Indigo Wiring Options. You can wire an input/output cable either through the opening on the back of the transmitter, or through the rubber lead-through on the bottom of the transmitter.
1
Wiring from the back: cut the seal open
2
Wiring through the rubber lead-through on the bottom of the transmitter
  1. To wire the input/output cable through the back of the transmitter:
    1. Cut off as much of the seal as is needed to fit your cable through the opening.
    2. Lead the cable through the opening and attach a strain relief as needed.
    3. If you wire only through the back, plug or seal the lead-through on the bottom.
  2. To wire the input/output cable through the rubber lead-through on the bottom:
    1. Push the input/output cable through the lead-through.
    2. The lead-through provides strain relief and holds the cable in place. Tightening is not required.
    The recommended cable diameter for wiring through the rubber lead-through is 7 ... 8 mm. If you use a different cable size, test that the strain relief works as intended.