Start the installation of RFL100 by performing the appropriate setup procedure:
- If you are connecting 1 humidity or temperature probe, see Setup with 1 humidity or temperature probe.
- If you are connecting 2 temperature probes using the probe splitter accessory, see Setup with 2 temperature probes.
- If you are connecting a carbon dioxide (CO2) probe, see Setup with CO₂ probe.
|CAUTION At least viewLinc Enterprise Server version 5.0 is required for connecting RFL100 data loggers. Setup instructions include additional firmware and hardware requirements for using RFL100 with 2 temperature probes, or a CO2 probe. Make sure the components of your viewLinc Monitoring System are updated to the required levels.|
When you switch on an RFL100 that has not been accepted to any viewLinc system yet, it starts to scan for VaiNet access points that are in installation mode. RFL100 will connect to the access point with the best signal strength, and wait to be accepted by the administrator of the viewLinc Enterprise Server. Make sure the access point(s) are installed and in installation mode before starting to set up RFL100 data loggers.