Configuring network connection - OPT100

OPT100 User Guide

Document code
English (United States)
Document type
User guide
Figure 1. IP address settings page

Configure the network settings of the external Ethernet connection (ETH0).

  1. Connect to the user interface as the Admin user.
  2. In the user interface, select Settings > Network > IP address.
  3. Select if the external Ethernet connection should be Enabled or Disabled.
  4. If you enabled the external Ethernet connection, select how its IP address is assigned: DHCP for automatic assignment, or Static IP address to enter the values manually.
  5. If you selected Static IP address, enter the following values:
    • IP address
    • Subnet mask
    • Default gateway

    IP addresses in cannot be used for the external network connection (ETH0) since they are reserved for the service port (ETH1).

  6. Select Apply to save your changes.