Configuring Modbus protocol - OPT100

OPT100 User Guide
Document code
M211858EN
Revision
AA
Language
English
Product
OPT100
Document type
User guide
Figure 1. Modbus settings page
  1. Connect to the user interface as the Admin user.
  2. In the user interface, select Settings > Network > Modbus.
  3. Select the connection type(s) for which Modbus protocol should be enabled. Select TCP (Ethernet), RTU (serial line), or both.
  4. If you enabled Modbus RTU, configure the serial connection:
    1. Select Baud rate for the connection. Available options are:
      • 4800
      • 9600
      • 19200
      • 38400
      • 57600
      • 115200
    2. Select Transmission mode, 8E1 or 8N2.
    3. Enter the Modbus Slave ID for the DGA monitor. Range 1–247.
  5. Click Apply to save your changes.