Installation safety - OPT100

OPT100 Installation Guide

Document code
Document type
User guide

Read the product documentation carefully before installing or operating the product. If you encounter the following marking during installation or operation, consult product documentation to find out the nature of the potential hazards and any actions which have to be taken to avoid them:

WARNING Only licensed experts may install electrical components. They must adhere to local and state legislation and regulations.
WARNING Make sure that you prepare and connect only de-energized wires.
WARNING Keep away from live circuits. Operating personnel must observe safety regulations at all times.
WARNING Ground the DGA monitor cabinets as instructed in the wiring instructions. Verify the grounding before and after performing maintenance on the unit.
CAUTION Do not modify the DGA monitor or use it in ways not described in the documentation. Modifications may lead to safety hazards, equipment damage, failure to perform according to specification, or decreased equipment lifetime.

Surfaces inside DGA monitor that are marked with the symbol below heat up during normal operation. Avoid touching hot surfaces and wear protective gloves when working inside the cabinet. Whenever possible, allow the DGA monitor to cool down before starting the work.

SLD235227-A-Hazard Warning Label
Wear protective eyewear and gloves.
Follow the safety regulations of the installation site.
The safety of any system incorporating this equipment is the responsibility of the assembler.