The
notation <cr>
refers to the carriage return control character, which
you can send in a terminal application by pressing Enter on your
keyboard. Before entering commands, send a <cr>
to clear the command
buffer.
You can enter the commands in uppercase or lowercase. In the command examples, the keyboard input by the user is in bold type.
Command | Description |
---|---|
Device information and status | |
? | Show device information. |
?? | Show device information (will respond in poll mode). |
errs | Show active errors. |
help | Show list of serial commands. |
system | Show firmware information. |
time | Show transmitter uptime (time since last reset). |
Serial line output and communication | |
addr | Show or set device address. |
close | Close connection to device in POLL mode. |
form | Set output format of measurement messages. |
intv | Set measurement output interval. |
open | Open connection to device in POLL mode. |
r | Start continuous output of measurement messages. |
s | Stop continuous output of measurement messages. |
sdelay | Show or set serial line turnaround delay. |
send | Output one measurement message. |
seri | Set serial line settings. Default is 19200 N 8 1. |
smode | Set serial line operation mode. |
unit | Set units to metric (m) or non-metric (n). |
Analog output | |
aerr | Show or set error level for analog output. |
amode | Show analog output settings. |
aover | Enable or disable analog output 10% over range. |
asel | Show or set analog output parameters and scaling. |
Calibration and adjustment | |
cdate | Show or set adjustment date. |
crh | User calibration for humidity measurement. |
crhclr | Clear user calibration for humidity measurement. Factory calibration remains. |
ct | User calibration for T measurement. |
ctclr | Clear user calibration for temperature measurement. Factory calibration remains. |
ctext | Show or set adjustment information text. |
fcrh | Two-point calibration after humidity sensor change. |
l | Show adjustment offset and gain. |
li | Set adjustment offset and gain. |
Other commands | |
filt | Show or set measurement filtering. |
frestore | Restore factory settings. Clears all user settings, factory calibration remains. |
reset | Reset the device. |