HMW110/112 and TMW110 installation - HMD110 - HMD112 - HMS110 - HMS112 - HMW110 - HMW112 - TMD110 - TMW110

HMDW110 Quick Guide
Document code
M211692EN
Revision
D
Language
English
Product
HMD110
HMD112
HMS110
HMS112
HMW110
HMW112
TMD110
TMW110
Document type
User guide
  • Medium size crosshead screwdriver (Pozidriv) for cover screws
  • Small flat head screwdriver for screw terminals
  • Two installation screws: Ø ≤ 3.5 mm, head Ø ≤ 8 mm
  • Depending on the wall material and screw type, you may need a drill and a suitable drill bit to make installation holes for the screws
  • Tools for cutting and stripping wires
  • 19-mm open-end wrench for tightening the cable gland
Figure 1. HMW110/112 and TMW110 installation
  1. Open the transmitter cover and use two screws (not included) to attach the transmitter to the wall. The probe and cable gland should point down.
  2. Open the transmitter cover and route the cable through the cable gland.
    Connect the wires to the screw terminals according to the wiring instructions.
  3. Tighten the cable gland and close the transmitter cover.
  4. Remove the yellow transport protection cap from the probe.