CAUTION To avoid strain on the connector, make sure you connect the cable properly. Too much strain may cause the cable to fall off, damage the cable or connector, or make the cable or connector susceptible to water leakage.
After preparing the sensor
cables, connect the cables to PMU701 or DRI701.
Turn the 2 orange lock levers of the connector to the open or middle position.
1
Open
2
Middle
3
Locked
Insert the connector in the correct port in PMU701 or DRI701.
Push the connector to the bottom of the port.
CAUTION Make sure that the
lock levers are in the open or middle position. Pushing the connector in place with the
lock levers in locked position will damage the lock levers.
Verify that both lock levers have turned to the locked position, or turn them
manually.
CAUTION Do not use force. If the lock levers do not turn to the locked
position easily, it means that the connector is not properly in place.