Connecting IR illuminator - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide

IR illuminators have a fixed 10‑m (33‑ft) cable. Connect the IR illuminators to the AC/DC power supply.

WARNING Make sure that you prepare or connect only de-energized wires.
CAUTION Always connect the IR illuminators to the regular AC/DC power supply, not the additional power supply for WMT700 heating.
Connecting IR illuminator to AC/DC power supply
  1. Lead the IR illuminator cable through the cabling box and the rubber flange.
  2. Connect the cable to the AC/DC power supply terminal according to the following table.
    Signal Wire color AC/DC power supply terminal Wire color Signal
    Not connected – dcok 13 – Not connected
    Not connected – |< |N 14 – Not connected
    +12 … 24 V input (second unit) Red + – Black Ground (second unit)
    +12 … 24 V input (first unit) Red + – Black Ground (first unit)
    Reserved for PMU701 – + – – Reserved for PMU701
  3. Cut or braid the unused wires according to the following table.
    Color Usage Action
    White Not used Cut.
    Yellow
    Orange Powering Braid together and insulate with electrical tape.
    Violet
  4. For strain relief, secure the cable to the PMU701 sensor grounding rail with a cable clamp.