Mounting HMP155 and DTR13 on lattice mast - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide
  • 5‑mm Allen key

Support arm DKPFIXP44HLTT is suitable for tubes of Ø 20 … 28 mm (0.79 … 1.10 in).

1
Radiation shield DTR13
2
HMP155
3
Flat washer A5,3 DIN125 A4 (2 pcs)
4
Spring washer B5 DIN127 A4 (2 pcs)
5
Hex screw M5×16 DIN912 A4 (2 pcs)
6
Support arm DKPFIXP44HLTT
7
Hex screw M6×30 DIN912 A4 (4 pcs)
8
Spring washer B6 DIN127 A4 (4 pcs)
9
Flat washer A6,4 DIN125 A4 (4 pcs)
10
Mounting plate
  1. Attach the support arm to the lattice mast.
    1
    Mounting plate
    2
    Flat washer A6,4 DIN125 A4 (4 pcs)
    3
    Spring washer B6 DIN127 A4 (4 pcs)
    4
    Hex screw M6×30 DIN912 A4 (4 pcs)
  2. Mount DTR13 to the support arm.
    1
    Flat washer A5,3 DIN125 A4 (2 pcs)
    2
    Spring washer B5 DIN127 A4 (2 pcs)
    3
    Hex screw M5×16 DIN912 A4 (2 pcs)
  3. Remove the protective cover from the probe.
  4. Lead the sensor cable through the connector cover, and attach the cable to the probe.
  5. Loosen the screw of the sensor clamp with your fingers and insert the HMP155 probe in the larger outer hole at the bottom of the radiation shield.
    1
    Hole for additional T‑probe
    2
    Hole for HMP155 probe
  6. Install the optional T‑probe.
    1
    Knob
    2
    O-ring
    3
    T‑probe adapter (221069)
    4
    Cable tie
    5
    T‑probe
    1. Insert the T‑probe into to the T‑probe adapter.
    2. Fasten the T‑probe into the adapter using the knob.
    3. Fasten the cable to the adapter with a cable tie.
    4. Insert the adapter into the smaller outer hole in DTR13.

    Do not pull the T‑probe cable from HMP155. The cable is fixed to the circuit board.

  7. Push the connector cover over the probe connector.
  8. Tighten the screw without using excessive force.
  9. Lead the sensor cable along the support arm and attach the cable to the support arm with cable ties. Connect the sensor cable to the M12 connector in HMP155.
Write down the sensor installation height and radiation shield type. This is needed for the metadata in the Web UI.