Mounting HMP155 and DTR13 on DKPFIXP44H support arm - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide
4‑mm Allen key
  1. Mount the DKPFIXP44H support arm to the mast with the clamp and screws provided so that the center of the radiation shield, when mounted, is at 2 m (7 ft) height.
  2. Mount the radiation shield DTR13 to the support arm and fix it with the screws provided.
  3. Remove the protective cover from the probe.
  4. Lead the sensor cable through the connector cover, and attach the cable to the probe.
  5. Loosen the screw of the sensor clamp with your fingers and insert the HMP155 probe in the larger outer hole at the bottom of the radiation shield.
    1
    Hole for additional T‑probe
    2
    Hole for HMP155 probe
  6. Install the optional T‑probe.
    1
    Knob
    2
    O-ring
    3
    T‑probe adapter (221069)
    4
    Cable tie
    5
    T‑probe
    1. Insert the T‑probe into to the T‑probe adapter.
    2. Fasten the T‑probe into the adapter using the knob.
    3. Fasten the cable to the adapter with a cable tie.
    4. Insert the adapter into the smaller outer hole in DTR13.

    Do not pull the T‑probe cable from HMP155. The cable is fixed to the circuit board.

  7. Push the connector cover over the probe connector.
  8. Tighten the screw without using excessive force.
  9. Lead the sensor cable along the support arm and attach the cable to the support arm with cable ties. Connect the sensor cable to the M12 connector in HMP155.