Mounting WMT700 on support arm using SENSORARMFIX60 - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide
5‑mm Allen key

When mounting WMT700 using the SENSORARMFIX60 mounting kit, place the sensor with the array facing up.

  1. Install the SENSORARMFIX60 mounting bracket on the support arm. Tightening torque 5 Nm.
    1
    Ø 60 mm (2.36 in) bracket
    2
    Sensor bar fixture part
    3
    Hex screw M6×60 DIN912 A4 (2 pcs)
    4
    Spring washer A6 DIN127 A4 (2 pcs)
  2. Make sure that the cable is firmly connected to the sensor. Make sure that you have replaced the mounting adapter with the connector cover kit.

    Make sure that you have replaced the mounting adapter with the connector cover kit.

  3. Holding the sensor from its body, run the sensor cable through the mounting bracket, and slide the sensor into the mounting bracket. Tighten the screws loosely.
  4. Align the sensor.