Mounting WXT530 on vertical pole mast with mounting kit - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide
2.5‑mm and 5‑mm Allen keys
CAUTION Handle with care. Any impact on the instrument or sensor array may cause damage and lead to incorrect measurements.

When mounting a transmitter on a pole mast, you can use an optional mounting kit to ease mounting.

WXT530 (WXT536) pole mast installation accessories
1
Mounting kit (212792)
2
Mounting adapter (WMSFIX60)
  1. Remove the adapter sleeve from the mounting kit.
  2. Lead the sensor cable through the mounting kit, and connect the cable to the bottom part of the sensor.
  3. Insert the mounting kit adapter to the transmitter bottom.
    1
    Protective cushion
    2
    Transmitter
    3
    Mounting kit
    4
    Pole
  4. Turn the kit firmly until you feel the adapter snap into the locked position.
  5. Holding the sensor from its body, run the sensor cable through the mounting adapter, and slide the sensor onto the adapter. Do not tighten the fixing screw yet.
    1
    Fixing screw
    2
    Mounting accessory between mounting kit and 60 mm tube (WMSFIX60)
    3
    Mounting kit (212792)
  6. Align the transmitter so that the arrow on the bottom of the transmitter points North.
  7. To attach the adapter to the pole mast, tighten the fixing screw of the mounting adapter.
  8. Remove the protective cushion.
When removing a transmitter from the pole, turn the transmitter so that it snaps out from the mounting kit. Realignment is not needed when replacing the device.