|
The same instructions apply to ENC653 installation.
| If the enclosure is installed in an equipment container or other indoor premises, you can leave out the cabling box and the radiation shield. |
You can install the enclosure on a wall or the back panel of a larger cabinet. If the cabinet wall or back panel is made of wood, sheet metal, aluminum, or plywood, use any suitable screws to attach the frame.
- 1
- Hole for anchor plug (4 pcs)
- 2
- Anchor plug (4 pcs)
- 3
- Flat washer A6.4 DIN125 A4 (4 pcs)
- 4
- Hex screw M6×40 DIN517 A4 (4 pcs)
- 5
- Washer with EPDM gasket 6.8/16×1.5/A2/EPDM (2 pcs)
- 6
- Hex screw M6×16 ISO7380 A4 (2 pcs)
- 7
- Enclosure mounting slot (2 pcs)
- 1
- Enclosure mounting slot (2 pcs)
- 2
- Hole for enclosure mounting screw (2 pcs)
- 3
- Hole for wall mounting (4 pcs)
-
Drill holes into the wall or the back panel. Use the mounting
frame as a guide.
- 1
- Hole for anchor plug (4 pcs)
- 2
- Anchor plug (4 pcs)
-
Attach the mounting frame to the wall or the back panel.
Make sure that the mounting slots on the mounting frame are facing up. - 1
- Flat washer A6.4 DIN125 A4 (4 pcs)
- 2
- Hex screw M6×40 DIN571 (4 pcs)
-
Attach the cabling box to the mounting frame of the
enclosure.
- 1
- Flat washer A6.4 DIN125 A4 (2 pcs)
- 2
- Hex screw M6×16 ISO7380 A4 (2 pcs)
-
Lift the enclosure by holding it from the battery mounting clamp
and the bottom of the enclosure.
-
Hang the enclosure onto the frame by sliding the mounting studs on
the back of the enclosure into the mounting slots of the frame.
-
Attach the enclosure to the mounting frame. Tightening torque
5 Nm.
- 1
- Washer with EPDM gasket 6.8/16×1.5/A2/EPDM (2 pcs)
- 2
- Hex screw M6×16 ISO7380 A4 (2 pcs)
1 Electronics not shown
2 Electronics not shown