Mounting ENC722 on wall or back panel - RWS200

RWS200 Installation Manual
Product status
Document code
M211608EN
Revision
AA
ft:locale
en-US
Product
RWS200
Document type
User guide
5‑mm Allen key

You can install the enclosure on a wall or the back panel of a larger cabinet. If the cabinet wall or back panel is made of wood, sheet metal, aluminum, or plywood, use any suitable screws to attach the frame.

ENC722 wall or back panel installation accessories
1
Hole for anchor plug (4 pcs)
2
Anchor plug (4 pcs)
3
Flat washer A6.4 DIN125 A4 (4 pcs)
4
Hex screw M6×40 DIN517 A4 (4 pcs)
5
Washer with EPDM gasket 6.8/16×1.5/A2/EPDM (2 pcs)
6
Hex screw M6×16 ISO7380 A4 (2 pcs)
7
Mounting slot (2 pcs)
ENC722 mounting frame for wall or back panel installation (front)
1
Enclosure mounting slot (2 pcs)
2
Hole for enclosure mounting screw (2 pcs)
3
Hole for wall mounting (4 pcs)
  1. Drill holes into the wall or the back panel. Use the mounting frame as a guide.
    1
    Hole for anchor plug (4 pcs)
    2
    Anchor plug (4 pcs)
  2. Place the anchor plugs in the drilled holes.
  3. Attach the mounting frame to the wall or the back panel.
    1
    Flat washer A6.4 DIN125 A4 (4 pcs)
    2
    Hex screw M6×40 DIN571 (4 pcs)
  4. Lift the enclosure by holding it from the ceiling and the bottom of the enclosure.
  5. Hang the enclosure onto the frame by sliding the mounting studs on the back of the enclosure into the mounting slots of the frame.
    1
    Washer with EPDM gasket 6.8/16×1.5/A2/EPDM (2 pcs)
    2
    Hex screw M6×16 ISO7380 A4 (2 pcs)
  6. Attach the enclosure to the mounting frame. Tightening torque 5 Nm.
1 Electronics not shown