Attaching OIF to EN-SCI ozone sensor frame - RS41-SGP - RS41-SG

RS41 Ozone Soundings User Guide
Product status
Document code
M211486EN
Revision
G
ft:locale
en-US
Product
RS41-SGP
RS41-SG
Document type
User guide
In addition to OIF and the ozone sensor frame, you need the following equipment:
  • M3 nuts (2 pcs) included in Ozone Interface Kit RSA
  • Drill with applicable drill bits
  • Socket wrench for M3 nuts
  • Screwdriver
CAUTION Keep the sensor in an upright position. The sensor contains liquid.
The following figure shows EN-SCI Model Z ozone sensor frame.
EN-SCI model Z sensor

To connect the ozone sensor frame and Ozone Interface Board OIF:

  1. Remove the wing nuts attached to OIF.
  2. Use a drill to make the holes in the ozone sensor frame bigger.
    Drilling the ozone sensor frame holes
  3. Attach OIF to the ozone sensor frame with the M3 hex nuts (2 pcs), a screw driver and a socket wrench.
    1. Tighten the nuts.
      Ozone sensor attached to the model Z frame with M3 nuts