Attaching OIF411 to SPC’s Ozone Sensor Frame - RS41-D - RS41-SG - RS41-SGM - RS41-SGP

RS41 Ozone Soundings User Guide
Document code
M211486EN
Revision
E
Language
English
Product
RS41-D
RS41-SG
RS41-SGM
RS41-SGP
Document type
User guide
Figure 1 shows how OIF411 is attached to Science Pump Corporation’s (SPC) Model ECC-6A ozone sensor frame. See also the steps below. You do not need any extra equipment to attach OIF411 to the ozone sensor frame, the wing nuts needed are included in OIF411.

For instructions on attaching OIF411 to Model Z ozone sensor frame, see Attaching OIF411 to EN-SCI Ozone Sensor Frame.

CAUTION Keep the sensor in an upright position. The sensor contains liquid.
Figure 1. Attaching OIF411 to Ozone Sensor
1
Wing nuts
2
Ozone sensor frame
3
OIF411

To connect the ozone sensor frame and Ozone Interface Board OIF411:

  1. OIF411 is equipped with two wing nuts at the back. Attach OIF411 to the ozone sensor with the wing nuts. See Figure 2 for an illustration.
    Figure 2. Wing Nuts on the Back of OIF411