All commands can be issued either in uppercase or lowercase.
The notation <cr> refers to pressing the carriage return (ENTER) key on your computer keyboard. Enter a <cr> to clear the command buffer before starting to enter commands.
Whenever you change any of the parameters
and want to store the changes permanently, use the SAVE command.
| Measurement parameters are referred to as quantities in the transmitter's software. |
| Command | Description |
|---|---|
| ? | Show transmitter information |
| ?? | Show transmitter information (POLL mode) |
| ACAL | Calibrate analog outputs |
| ADDR | Set/show device address |
| AERR | Set/show analog output error levels |
| AMODE | Set/show analog output mode |
| AOUT | Show analog output status |
| ASEL | Set/show analog output parameters and scaling |
| ATEST | Test analog outputs |
| CALCS | Set/show measured parameters |
| CDATE | Set/show calibration date |
| CLOSE | Start POLL mode |
| CRH | Calibrate probe RH |
| CRHCLR | Restore probe RH factory calibration |
| CT | Calibrate probe T |
| CTCLR | Restore probe T factory calibration |
| CTEXT | Set/show calibration info |
| DSEL | Set/show displayed parameters |
| ECHO | Set/show terminal echo mode |
| ENV | Set/show environmental parameters |
| ERRS | Display active errors |
| FORM | Set/show output formatting |
| FRESTORE | Restore all transmitter settings to factory defaults |
| HELP | List available commands |
| INTV | Set/show the continuous output interval |
| OPEN | Stop POLL mode |
| R | Start continuous outputting |
| RESET | Reset transmitter |
| RESTORE | Restores the latest saved settings |
| RMODE | Set/show relay operating mode |
| ROUT | Show all relay-related parameters |
| RSEL | Set/show relay parameter |
| S | Stop continuous outputting |
| SAVE | Save changed settings to FLASH memory |
| SDELAY | Set/show RS-485 turnaround time for user port |
| SEND | Output the reading once |
| SERI | Set/show service port settings (default: 19200 N 8 1) |
| SERI2 | Set/show user port settings (default: 19200 N 8 1) |
| SMODE | Set/show the serial interface mode |
| SYSTEM | Show transmitter information and build date |
| UNIT | Set/show output unit |
| VERS | Show firmware version of the transmitter |